With Ascend Detect AI activated, as you acquire an individual image or a series, each image is submitted to Videa Health automatically for analysis as applicable.
When you finish the acquisition, the following can display on the image automatically:
-
Results of the bone level analysis - Dashed lines display on the image where bone levels were measured. The color of a line (white, green, yellow, orange, or red) is determined by the severity of the calculated bone loss. Also, purple dots display on the image where root apexes (if any) were detected.
-
Results of the caries analysis (if applicable) - Boxes display on the image where areas of concern were detected.
Note: The number of caries detections and bone level measurements display in fine print at the bottom of the image.
Note: If an error occurs during submission, on the error message that displays, complete one of the following:
-
To resubmit the image for analysis, clicktap Re-Submit.
-
To end the acquisition mode without resubmitting the image for analysis, clicktap Finish Acquisition. You can manually submit the image for analysis later.
-
To continue to the next step in the acquisition sequence without resubmitting the current image for analysis, clicktap the X. You can manually submit the image for analysis later.
Complete any of the following:
-
If you have acquired a series with other periapicals or bitewings, to view the bone level and caries detection results for another image in that series, clicktap that image under Image Navigator.
-
For a selected periapical or bitewing, select the AI tool.
The number of bone level measurements and areas of concern that were detected display on the left.
Notes:
-
If the Auto-Submit Historical Images checkbox is selected, when you view any image that was not analyzed previously, the image is submitted for analysis automatically.
-
You can position your pointer over a bone level measurement to view the calculated percentage of bone loss.
-
To switch between showing and hiding the bone level indicator lines, root apex indicator dots, and caries indicator boxes, clicktap the Select object(s) to Display
icon to display the Select Object(s) to Displaywindow, select or clear the AI Findings checkbox, and clicktap Confirm.
-
To switch between showing and hiding all annotations, measurements, bone level indicator lines, root apex indicator dots, and caries indicator boxes for the image, clicktap the Show/hide annotations and measurements
icon. The icon is only available if an annotation, a measurement, bone level analysis, or caries analysis has been applied to the image.
-
Note: If you rotate an image or zoom in or out, it is automatically resubmitted for analysis, and it may take 3-5 seconds for the indicator boxes and lines to redisplay.
Comments
0 comments
Please sign in to leave a comment.